Lowrance-electronic LMS 335C DF Uživatelský manuál Strana 40
- Strana / 216
- Tabulka s obsahem
- ŘEŠENÍ PROBLÉMŮ
- KNIHY
Hodnocené. / 5. Na základě hodnocení zákazníků
32
If the base of the transom has a radius, fill the gap between the tran-
som and the sensor with the sealant. This will help ensure a smooth
water flow.
Route the sensor's cable through or over the transom to the sonar unit.
If you need to drill a hole in the transom to pass the connector through,
the required hole size is 7/8".
CAUTION:
If you drill a hole in the transom for the cable, make sure it is lo-
cated above the waterline. After installation, be sure to seal the
hole with the same marine grade above- or below-waterline seal-
ant used for the screws.
The sensor is now ready for use. Connect the sensor to the sonar socket
on the back of your unit and connect the transducer to the speed sensor's
socket (see drawing on page 41). If you have any questions concerning
the installation of the sensor, please contact your local boat dealer.
GPS Antenna/Receiver Module
This unit's package includes the LGC-2000 GPS module. This device con-
tains the unit's external antenna and receiver for GPS and WAAS signals.
The antenna/receiver module comes with a 25-foot Y-adapter extension
cable. This module can be mounted on a flat surface or pole, or an optional
magnet is available for temporary mounting on any ferrous surface.
LGC-2000 Module, bottom view (left) and top view (right).
Tools required for installation are: wire pliers, flat screwdriver, drill, 1"
(25 mm) drill bit and 3/16" (4.75 mm) drill bit.
The LGC-2000 requires 9 to 20 volts DC power. It draws power through
the unit or from the NMEA 2000 buss (instructions on powering a
NMEA 2000 buss appear later in this section).
The GPS module can be mounted on any flat surface, provided there is
access behind the mounting surface for the screws. The optional mag-
net allows the module to be easily used on cars or off-road vehicles. The
pole mount adapter lets you mount the antenna on a pole or swivel
mount that uses standard marine 1" - 14 threads.
- LMS 330C & 1
- LMS 335C DF 1
- Table of Contents 3
- Section 1: Read Me First! 9
- How Lowrance Sonar Works 13
- How Lowrance GPS Works 14
- Introduction to GPS and WAAS 16
- Free Training Aids Available 18
- MENU 20
- ENT 20
- Section 2: 23
- Hull bottom 26
- Transducer 26
- Ratchets 29
- Second bottom 36
- True bottom 36
- Manual range setting 36
- Epoxy transducer to hull 37
- Spread epoxy here 37
- Sand this surface 37
- Speed/Temperature Sensors 38
- GPS Antenna/Receiver Module 40
- Surface Mount 41
- Magnet Mount 41
- Power Connections 44
- NMEA 2000 Cable Connections 47
- NMEA 0183 Cable Connections 48
- Template 52
- Face Cover 53
- Other Accessories 54
- Keyboard 55
- PAGES key, then 58
- AP 60
- ONAR 60
- Basic Sonar Quick Reference 63
- Sonar Operations 64
- MENU 65
- Sensitivity Control Bar 65
- Important Tip: 66
- MENU 67
- NOISE REJECTION 67
- EXIT 68
- LARMS 70
- Calibrate Speed 71
- Chart Speed 72
- ColorLine 73
- Depth Cursor 74
- Depth Range - Automatic 75
- Depth Range - Manual 75
- PPER AND LOWER LIMITS 76
- FasTrack 77
- FishTrack 79
- (LMS-335C DF only) 79
- HyperScroll 80
- IceView Chart Mode 81
- (Signal Interpretation) 81
- Log Sonar Chart Data 82
- Noise Rejection 83
- Overlay Data 83
- VERLAY DATA 84
- ATA 84
- Ping Speed & HyperScroll 85
- ING SPEED 86
- Reset Water Distance 87
- Set Keel Offset 88
- Sonar Chart Mode 90
- ONAR FEATURES 91
- ONAR COLOR MODE 91
- USTOMIZE 93
- Sonar Simulator 96
- Stop Chart 98
- Surface Clarity 99
- Upper and Lower Limits 100
- Zoom & Zoom Bar 100
- Zoom Pan 100
- ↓ to pan up and 101
- Section 5: 103
- Sonar Troubleshooting 103
- Basic GPS Operations 107
- Section 6: 107
- Power/lights on and off 108
- Main Menu 108
- AVIGATION 112
- PAGES 114
- AP 118
- ESIZE WINDOW 119
- Basic GPS Quick Reference 120
- Find Your Current Position 121
- Searching 122
- ESTAURANTS 123
- AST FOOD CHAINS 123
- EAREST 123
- Set a Waypoint 125
- Y WAYPOINTS 126
- Navigate To a Waypoint 127
- Navigate Back to MOB Waypoint 128
- ANCEL NAVIGA 129
- Creating and Saving a Trail 130
- Y TRAILS 131
- Displaying a Saved Trail 132
- Navigating Trails 133
- OAD 137
- AVE DATA 137
- Cancel Navigation 138
- Section 7: 139
- Advanced GPS Operations 139
- ELETE MY ICONS 141
- PC-created Routes 142
- Routes Created in the Unit 142
- OUTE PLANNING 146
- ELETE TRAIL 148
- ELETE ALL 148
- Y TRAILS 148
- Y TRAILS 149
- Utilities 150
- Waypoints 150
- Section 8: 153
- Configure NMEA 155
- Coordinate System Selection 156
- EXIT to erase this menu 157
- Configure Loran TD menu 157
- ETUP 158
- OORDINATE SYSTEM 158
- ETUP MAP FIX 158
- Customize Page Displays 159
- GPS Simulator 159
- Hide GPS Features 161
- Initialize GPS 161
- Map Auto Zoom 161
- Map Data 162
- Map Datum Selection 163
- Map Detail Category Selection 164
- Map Orientation 165
- Navionics 166
- ERVICE CATEGORIES, press ↓ 168
- Pop-up Help 171
- Position Pinning 172
- Reset Options 172
- Require WAAS 173
- Set Language 174
- Set Local Time 175
- Show WAAS Alarm 175
- Software Version Information 176
- Sounds and Alarm Sound Styles 176
- Track Smoothing 177
- Trail Options 178
- Transparency 180
- Units of Measure 181
- Section 9: Searching 183
- Find Addresses 184
- IND AD 186
- Find Interstate Highway Exits 187
- Find Streets or Intersections 192
- IND STREETS 194
- ECOND STREET 194
- Find Waypoints 196
- IND ON MAP 197
- ENT. (Go To Waypoint com 198
- FIND ON MAP 198
- Datums Used by This Unit 199
- FCC Compliance 203
- DATABASES LIMITED WARRANTY 212
- FULL ONE-YEAR WARRANTY 213
- LOWRANCE ELECTRONICS 213
- How to Obtain Service… 214
- Shipping Information 215
- Visit our web site: 216
Související produkty a manuály pro GPS přijímač Lowrance-electronic LMS 335C DF
GPS přijímač Lowrance-electronic 480C Uživatelský manuál
(140 stránky)
(140 stránky)
Ofm 408-C manuels
Manuels d'utilisation et guides de l'utilisateur pour Meubles Ofm 408-C.
Nous fournissons des manuels en pdf 1 Ofm 408-C à télécharger gratuitement par type de document : Manuel de l'utilisateur
Komentáře k této Příručce